HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Controlling program exit

Post Reply 
Controlling program exit
11-17-2020, 10:15 PM
Post: #14
Han Offline
Senior Member
 		Posts: 1,882
Joined: Dec 2013
RE: Controlling program exit
If you place a DEBUG command right before the UNTIL command, you can then view the contents of all the variables right before the UNTIL command is executed. That may give you some insight into to state of the program. It is possible you may have even found a bug (can't say either way since I don't have my calculator with me).
Graph 3D | QPI | SolveSys
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Controlling program exit - cahlucas - 11-13-2020, 05:03 PM
RE: Controlling program exit - cahlucas - 11-13-2020, 10:16 PM
RE: Controlling program exit - Han - 11-13-2020, 10:44 PM
RE: Controlling program exit - cahlucas - 11-13-2020, 11:08 PM
RE: Controlling program exit - Jacob Wall - 11-14-2020, 04:31 PM
RE: Controlling program exit - cahlucas - 11-15-2020, 07:55 PM
RE: Controlling program exit - Jacob Wall - 11-15-2020, 10:58 PM
RE: Controlling program exit - cahlucas - 11-17-2020, 05:31 PM
RE: Controlling program exit - Jacob Wall - 11-17-2020, 09:08 PM
RE: Controlling program exit - cahlucas - 11-18-2020, 05:55 PM
RE: Controlling program exit - Han - 11-17-2020 10:15 PM
RE: Controlling program exit - Han - 11-18-2020, 09:41 PM
RE: Controlling program exit - cahlucas - 11-20-2020, 01:59 AM
RE: Controlling program exit - Han - 11-21-2020, 04:53 PM
RE: Controlling program exit - cahlucas - 11-21-2020, 11:54 PM
RE: Controlling program exit - Han - 11-30-2020, 01:57 AM
RE: Controlling program exit - cahlucas - 11-30-2020, 10:01 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication