Post Reply 
3D Printed Overlay for DM42, DM41X ...
02-12-2021, 11:16 PM (This post was last modified: 02-12-2021 11:20 PM by Craig Bladow.)
Post: #6
RE: 3D Printed Overlay for DM42, DM41X ...
I ran a quick test, see attached. The results could be improved by using a smaller nozzle than the 0.4 mm used here and perhaps PLA vs. PETG (used here) which is a little more stringy.

   

CC41 coming soon!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 3D Printed Overlay for DM42, DM41X ... - Craig Bladow - 02-12-2021 11:16 PM



User(s) browsing this thread: 1 Guest(s)