Making a new Program from Connectivity Kit crashes G2

[matalog]

(06-29-2021 10:02 AM)Thomas_Sch Wrote:  No crashes here, following your steps.

I wrote only a simple minimal test program, and used "Send to class" to transfer this program to the virtual calcluator. Syntax check etc. was done on the virtual calculator, because this is not supported in connectivity kit.

I don't even get a chance to type a program in.

I am talking only about a real G2 Prime on PC.

When I connect it and right click Program, then select New Program, and then type in a name and press enter, the calculator reboots.