HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / multi criteria IF statement

Post Reply 
multi criteria IF statement
06-13-2021, 03:19 PM
Post: #11
toml_12953 Offline
Senior Member
 		Posts: 2,083
Joined: Dec 2013
RE: multi criteria IF statement
(06-13-2021 01:10 PM)Joe Horn Wrote:  
(06-13-2021 05:35 AM)toml_12953 Wrote:  The bug must have been fixed again. I get the proper 45 with all the examples in that thread.

Strange... my G2 running firmware 14588 (2021 05 05) still has that bug (namely, arg(3+3.*i) in CAS view returns its answer in radians even when Prime is in Degrees mode). Make sure you're in CAS view, degree mode, and include the decimal point.

I just checked it again. Now it comes up with radians. I was sure I checked the angular mode before but I must not have. Of course in Home mode, it does work properly and that's the mode I always use so I never would have run into this bug.
Tom L
Cui bono?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
multi criteria IF statement - Amer7 - 06-11-2021, 11:06 AM
RE: multi criteria IF statement - Amer7 - 06-11-2021, 11:59 AM
RE: multi criteria IF statement - Dougggg - 06-12-2021, 03:05 AM
RE: multi criteria IF statement - Joe Horn - 06-13-2021, 01:10 PM
RE: multi criteria IF statement - toml_12953 - 06-13-2021 03:19 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication