testing a 41cv before attempting lower post repair
|
07-24-2021, 10:45 PM
Post: #5
|
|||
|
|||
RE: testing a 41cv before attempting lower post repair
I replaced the lower posts on my 41CL conversion with 2-56 threaded standoffs cut to length and reduced to the correct diameter. I used two part epoxy to glue them in place, using the screws and the lower case in place to ensure they ended up in the correct position. It is critical to not touch it for at least 24 hours to ensure the epoxy cures and bonds fully. I think I roughed up the plastic of the top case under where the standoffs attach.
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
testing a 41cv before attempting lower post repair - dmh - 07-21-2021, 08:38 AM
RE: testing a 41cv before attempting lower post repair - mfleming - 07-21-2021, 02:30 PM
RE: testing a 41cv before attempting lower post repair - dmh - 07-24-2021, 07:28 AM
RE: testing a 41cv before attempting lower post repair - BillBee - 07-26-2021, 10:19 AM
RE: testing a 41cv before attempting lower post repair - mfleming - 07-24-2021, 02:45 PM
RE: testing a 41cv before attempting lower post repair - cruff - 07-24-2021 10:45 PM
RE: testing a 41cv before attempting lower post repair - dmh - 07-26-2021, 11:32 AM
RE: testing a 41cv before attempting lower post repair - cruff - 07-26-2021, 12:32 PM
|
User(s) browsing this thread: 1 Guest(s)