Post Reply 
HP82143A Rollers
09-17-2021, 09:57 AM
Post: #6
RE: HP82143A Rollers
(09-14-2021 11:08 PM)cesarb94 Wrote:  I'm glad it was of help!

Actually my first try at it was stretching out the o-rings from an HP67 repair kit I had laying around, but did not get reliable results. The ones I used in the final repair (4.47 ID x1.78 Th)mm are a little larger than those for the 67 and now the printer runs perfectly.

Best regards.

I did it. Thanks! It’s working fine.
But it kind of a pain to do because mine is a bit different inside than yours. The head doesn’t tilt back because of an extra tab on the back.. I forgot to put a dab of C.A glue, but it still works just fine.
One of the original rings was ok-ish. So I measured it with calipers.
I filed down the ends of the axe a bit to have pretty much the same overall
diameter with the O-Rings on. It’s still a tad larger (+.06mm), but it’s fine. It makes a bit of a rubbing noise because of the extra pressure, but that’s ok.

Engineer & Senior IT Executive
2x HP41CL, HP41CX, HP48GX, HP50g, 2x82162A Printer, 2x82143A Printer, 2x HP-IL, 2x Card-Readers, PIL-BOX.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP82143A Rollers - Neve - 09-14-2021, 08:16 PM
RE: HP82143A Rollers - cesarb94 - 09-14-2021, 09:54 PM
RE: HP82143A Rollers - Neve - 09-14-2021, 10:09 PM
RE: HP82143A Rollers - Neve - 09-14-2021, 10:56 PM
RE: HP82143A Rollers - cesarb94 - 09-14-2021, 11:08 PM
RE: HP82143A Rollers - Neve - 09-17-2021 09:57 AM
RE: HP82143A Rollers - cesarb94 - 09-17-2021, 11:38 PM
RE: HP82143A Rollers - Neve - 09-18-2021, 06:29 AM



User(s) browsing this thread: 1 Guest(s)