Slide rule cursor misaligned, how did happen?
|
09-26-2021, 06:41 AM
(This post was last modified: 09-26-2021 06:46 AM by Garth Wilson.)
Post: #4
|
|||
|
|||
RE: Slide rule cursor misaligned, how did happen?
(09-26-2021 02:49 AM)Geoff Quickfall Wrote: To align the slide you position the cursor over the right all left indices. Then loosen the screws and adjust the glass in the frame so that it is parallel to the left or right indices. The C and D scales are aligned with each other, but the CF and DF scales are not aligned with each other. You'll need to loosen the screws that brace the two long stationary pieces of wood, and align those pieces. When they're perfect, then see if the cursor is still needing alignment, using the two outer scales and seeing if, for example, the .5 on the LL02 (top) scale lines up with the 2 on the LL2 (bottom) scale, and adjusting the cursor if they don't. http://WilsonMinesCo.com (Lots of HP-41 links at the bottom of the links page, http://wilsonminesco.com/links.html ) |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Slide rule cursor misaligned, how did happen? - butforwales - 09-26-2021, 01:39 AM
RE: Slide rule cursor misaligned, how did happen? - Geoff Quickfall - 09-26-2021, 02:49 AM
RE: Slide rule cursor misaligned, how did happen? - Garth Wilson - 09-26-2021 06:41 AM
RE: Slide rule cursor misaligned, how did happen? - butforwales - 09-26-2021, 03:43 AM
RE: Slide rule cursor misaligned, how did happen? - Benjer - 09-26-2021, 08:13 AM
RE: Slide rule cursor misaligned, how did happen? - Ren - 09-26-2021, 09:35 PM
|
User(s) browsing this thread: 2 Guest(s)