Sharp PC-1403H stuck on "BUSY"
|
01-27-2022, 12:46 PM
(This post was last modified: 01-27-2022 01:18 PM by david sanz.)
Post: #3
|
|||
|
|||
RE: Sharp PC-1403H stuck on "BUSY"
(01-27-2022 04:05 AM)Didier Lachieze Wrote: This looks like a memory issue. I would check the memory chip to see if there is any bad solder joint. Same problem here with a PC-1403 Thanks for the tip. Funny thing is machine is unresponsive to ON/OFF switch position. Remains BUSY even if tab in OFF position. Reset buttom does not help. Switches off when Reset pressed, but return to BUSY when Reset released. No obvious corrosion/dirt on board. Anyway, a nice looking machine. I do not think I would make much use of it, even if it worked. edit: vendor claimed issue arised after a battery replacement. Perharps pressure on board during replacement set lose the chip ? good luck, Dave. If you are lucky, maybe I will |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Sharp PC-1403H stuck on "BUSY" - Dave Britten - 01-26-2022, 09:31 PM
RE: Sharp PC-1403H stuck on "BUSY" - Didier Lachieze - 01-27-2022, 04:05 AM
RE: Sharp PC-1403H stuck on "BUSY" - david sanz - 01-27-2022 12:46 PM
RE: Sharp PC-1403H stuck on "BUSY" - Dave Britten - 01-27-2022, 12:55 PM
RE: Sharp PC-1403H stuck on "BUSY" - Dave Britten - 01-27-2022, 04:18 PM
|
User(s) browsing this thread: 1 Guest(s)