HP-25 Co-luminous segments
|
04-07-2022, 03:59 PM
Post: #8
|
|||
|
|||
RE: HP-25 Co-luminous segments
Hello!
(04-07-2022 03:08 PM)Tom Flatterhand Wrote: i have attached 2 pictures. Can you tell from the pictures what condition they are in? From your pictures it looks as if they are a bit mushy or soft. I can see some dust sticking to them. So I don't think they will come out in one piece. I have not tried that yet, but maybe after an hour in the freezer the rubber hardens sufficiently to be pulled out undamaged. Alternatively you could just drill a small hole in each them (2 or 2.5mm should be sufficient) to access the screws. A small Phillips screwdriver is required for that. That would leave most of the rubber feet in place. The screw holes are not in the centre of the rubber feet but a little offset to the center of the calculator. I attach a photo below (this is the rubber foot on the right hand side, the left one is just mirrored). Regards Max |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)