New HP-71 zebra strips?
|
06-11-2022, 10:02 PM
Post: #4
|
|||
|
|||
RE: New HP-71 zebra strips?
(06-11-2022 08:42 PM)Dave Frederickson Wrote: If your 71 is of the metal back variety, with screws on the back and spring connectors in the battery compartment, the two PCB's will be connected with a delicate ribbon cable. If your 71 is of the plastic back variety, with foam sprung contacts and a screw in the battery compartment then it will have a golden zebra connecting the boards Thanks. From the picture it looks like a plastic back to me. It took me a few tries to get the size right on the first zebra strips I had made. Getting the height just right, to get the right amount of compression, is a bit of an educated guess. I'm guessing since you say 'golden zebra' it is of the type shown here: https://www.fujipoly.com/usa/products/ze...ctors.html. These seem to take less pressure to make a good contact than the silicone rubber type. I'm not sure the silicone type, which is easier to get made in small quantities, will work. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)