What am I doing wrong - HP42 (DM42)
|
10-04-2022, 02:18 AM
Post: #2
|
|||
|
|||
RE: What am I doing wrong - HP42 (DM42)
Some things to try, in this order, checking if it's fixed after each step:
1. Shift-SETUP-2 Load Clean State 2. Insert a paper-clip into the reset hole on the back side 3. Reinstall the latest DM42 firmware, available here: https://forum.swissmicros.com/viewtopic.php?f=16&t=3187 If none of these steps solves the problem, it is likely a h/w issue. How old is this DM42? --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
What am I doing wrong - HP42 (DM42) - rkumetz - 10-03-2022, 04:32 PM
RE: What am I doing wrong - HP42 (DM42) - rprosperi - 10-04-2022 02:18 AM
RE: What am I doing wrong - HP42 (DM42) - Didier Lachieze - 10-04-2022, 04:37 AM
RE: What am I doing wrong - HP42 (DM42) - rprosperi - 10-04-2022, 12:22 PM
RE: What am I doing wrong - HP42 (DM42) - rkumetz - 10-04-2022, 12:38 PM
RE: What am I doing wrong - HP42 (DM42) - Thomas Okken - 10-05-2022, 05:07 AM
Swiss Micros Support - rkumetz - 10-04-2022, 12:42 PM
RE: What am I doing wrong - HP42 (DM42) - rprosperi - 10-05-2022, 02:02 AM
|
User(s) browsing this thread: 1 Guest(s)