HP-71B Auto on

[Erwin]

@Sylvain @J-F
thanks a lot. Maybe it is from my programming the FRAMB new and the HPIL is broken - cause I did no disconnect properly.
So I tried the first step ... RESTORE IO --> Result: HPIL Look broken. So I connected the loop and did the same with positive result, Afterwards I did the RESET IO.
So I let it in this state and look at it after tomorrow. If this fails I'll try the. next proposals.
Thanks for learning me some secrets :-)

In the next weeks I put some of my equipment together (second HP71B, and some modules, some HPIL devices I have in double etc) cause I have the FRAMB and I'm very satisfied with it.
Will the doubled parts leave to people who are happy with it. I only keep the core elements, cause I use the HP71B and some peripherals (printer, disc serial HPIL)

So thanks a lot for your hints - I will give feedback about the results

best regards from Vienna, Austria
Erwin