HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / USBOpen(), USBSend() and USBRecv()

Post Reply 
USBOpen(), USBSend() and USBRecv()
05-01-2023, 07:23 PM (This post was last modified: 05-01-2023 07:30 PM by matalog.)
Post: #12
matalog Offline
Senior Member
 		Posts: 348
Joined: May 2021
RE: USBOpen(), USBSend() and USBRecv()
I have tested further, sending 26 bytes from 3 different Terminal programs, "abcdefghijklmono....", it only picks up 10 of them.

Then if I send from PC "abcdefghijklmono...." followed by "12" it stores 10 bytes from "abcd...." and also "12" when I have not used USBRecv() yet and will hold on to them until I use USBRecv().

[Image: 1.png?dl=1]
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: USBOpen(), USBSend() and USBRecv() - matalog - 05-01-2023 07:23 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication