[WP 31s] difficulty with STO/ RCL X Y Z T
|
10-19-2014, 06:09 PM
(This post was last modified: 10-19-2014 06:34 PM by BobVA.)
Post: #2
|
|||
|
|||
RE: [WP 31s] difficulty with STO/ RCL X Y Z T
I believe to access X, Y, Z and T you actually need to prefix the register with the ENTER key. For example:
17 STO ENTER T will put 17 in the T register RCL ENTER T will recall the value in the T register. (Please see the table about "Addressing Real Numbers" on Page 27 of the WP34 manual for the definitive discussion!) |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[WP 31s] difficulty with STO/ RCL X Y Z T - Stephan2 - 10-19-2014, 05:26 PM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - BobVA - 10-19-2014 06:09 PM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - Jonathan Cameron - 10-19-2014, 07:06 PM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - Stephan2 - 10-19-2014, 07:51 PM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - Jonathan Cameron - 10-19-2014, 08:03 PM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - Stephan2 - 10-19-2014, 10:42 PM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - Jonathan Cameron - 10-19-2014, 11:36 PM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - Stephan2 - 10-20-2014, 09:58 AM
RE: [WP 31s] difficulty with STO/ RCL X Y Z T - Paul Dale - 10-19-2014, 09:14 PM
|
User(s) browsing this thread: 1 Guest(s)