WP 34S and 31S bugs and fixes

[Bit]

(12-23-2014 08:50 PM)Nigel (UK) Wrote:  Mini-bug in r3716 and probably earlier ones too:

With the calc_full.bin firmware, the X.FCN catalogue has a ??? entry in between sRCL and TIME (where the STOPW application would be). Executing this gives an "Undefined op-code" error, which should never happen according to the manual! A problem caused by this is that searches for commands near the end of the alphabet get stuck at this point, rather than reaching the correct command.

Nigel (UK)

I couldn't reproduce this issue.

Which binary were you using? Did you compile it yourself? If so, which compiler did you use and what was in features.h?