(05-28-2015 05:44 AM)Ángel Martin Wrote: [ TVM module ]
It's posted at TOS but I cannot copy-paste the link here as we all know. I can send you the module via email, pls. send me your address via PM.
Got it (thank you), and installed it on V41 version 8.
Here are the results:
- After turning on V41 the auto-assignment starts ("Working..."). But the assigned functions are not those of the TVM module. Function names like BITVIEW or ROTXY seem to refer to a different ROM. I had the Advantage ROM installed. After removing this, everything works fine. Now only TVM 1E and the P#4 library are installed.
- Then I tried the sample problem posted earlier. After calling "I$" the display shows "Running...", then the correct solution is returned. I expected the result to be slighty off, like the one you posted, but actually it is exact in all 10 digits: "I=14,43587133". Great.
- For this result the I$ function required about 9 seconds on V41. This is about the same as on my hardware 41CV with a simple FOCAL program. I am using V41 version 8 with default speed settings, which runs faster than my hardware 41CV. However, I noticed that after 4 seconds the "Running..." display flickered a few times.
- I tried the same example in BEGIN mode. This time the I$ function required 19 seconds on V41, and the result was correct when rounded to 8 significant digits: "I=10,20509781".
I admit I would not have expected times near 10 or 20 seconds on V41. This would translate to about 15...30 seconds on a physical '41. Do you think there is something wrong with my V41 setup?
Dieter