New Version: 2015.06.17
|
06-24-2015, 08:54 AM
Post: #18
|
|||
|
|||
RE: New Version: 2015.06.17
It wasn't seamless but I finally got my firmware updated.
Setup: Win 7 64 bits in a Parallels 9 VM on OSX 10.8.5 Problems: The initial update failed with "Command error" on the calculator. I had some trouble getting it back into recovery mode. Neither a paper clip reset nor the C-F-O reset worked for me. Finally ON+Symb got me back to recovery mode and the Conn Kit was able to find and update the calculator. Possible cause: There are some delays when the USB device mode is being changed between Recovery Mode and normal HID mode. The VM needs to reconnect the USB port and inside the VM the drivers need to be installed before the update can proceed. it would be helpful if the Conn Kit gave on screen instructions to the user in case an update fails. Marcus von Cube Wehrheim, Germany http://www.mvcsys.de http://wp34s.sf.net http://mvcsys.de/doc/basic-compare.html |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)