result on the display of HP50g
|
09-06-2015, 02:11 PM
Post: #20
|
|||
|
|||
RE: result on the display of HP50g
(09-06-2015 03:04 AM)Skyblues Wrote: 2) I copy the following to the stack ... Almost... There are special characters in the 50g which are not used or available on the PC, so a system evolved to show these special symbols using normal ascii characters which all begin with a "\" character. In the above program, there are 3 of these: \<< - this is the start of an RPL program \>> - this is the end of an RPL program \=/ - this is the Not Equals symbol You can see a list of all of these special characters here. When you enter a program, you start by adding the opening and closing symbols for an RPL program (these are entered via [RS] [+] ). This leaves the cursor between the start and end symbols. Then continue to type in the program as you see in the listing. When you get to the symbol for Not Equals in the second line, enter this using [LS] [+/-], then finish entering the program. When done, store it as discussed, but note that you should remove the old version ('VIEW' [TOOL] [F5-PURGE] ). --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)