Plastic (or Aluminum as you want) case for NP-25

[Francois Lanciault]

(12-16-2015 07:52 PM)Massimo Gnerucci Wrote:  

(12-16-2015 04:48 PM)Waon Shinyoe Wrote:  The original overlay was printed on the NP-25's PCB. The space is quite limited while NP-25 can emulate multiple models. (HP 21, HP 25C and HP 33C) Even though, Chris managed to squeezed into quite a lot nomenclatures.

If we want a customized overlay for each ROM, then the overlay should be switchable, which may require the HP-41 series design. I can make the front edge taller to hold a new overlay. Thanks Walter, I will consider the design. Maybe the new design will be adopted after I customize the overlays.

Good news!
Once redesigned to accept overlays I will get an aluminium one.

Thank you.

I may be late to the party but what do I need to do to get a NP-25 in the first place ?

François