Post Reply 
Plastic (or Aluminum as you want) case for NP-25
12-18-2015, 01:31 PM
Post: #14
RE: Plastic (or Aluminum as you want) case for NP-25
@WAON

A reminder.. cannot see how the PCB sits on top of the sunken base. Your NP25 was assembled without cutting short the DIP ICs. Instead I had raised them a bit so that their pins is not protruding through the back side (or front). So your build is thicker where the back side IC was.

Not sure how it will affect your design and how it fits other units. Please check original thread there are many photos on the older build units.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Plastic (or Aluminum as you want) case for NP-25 - Chris Chung - 12-18-2015 01:31 PM



User(s) browsing this thread: 1 Guest(s)