Service required for HP 9160A Optical Card Reader
|
01-06-2016, 03:07 AM
Post: #17
|
|||
|
|||
RE: Service required for HP 9160A Optical Card Reader
I was just reading one of your earlier posts:
(01-03-2016 09:33 PM)Jurgen Keller Wrote: At least the transport roll was totally rotten. I couldn't even measure the correct diameter. So I replaced it with a gummy ring that might not fit well. However, I've no idea if that can have a bad impact on the correct operation. Did you originally have the card reader connected before replacing the drive wheel, and was it blowing fuses then? I'm wondering if this new wheel is creating too much friction. David Brunell Houston, Texas |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)