Post Reply 
Service required for HP 9160A Optical Card Reader
01-06-2016, 08:50 PM
Post: #19
RE: Service required for HP 9160A Optical Card Reader
(01-06-2016 03:07 AM)quantalume Wrote:  I was just reading one of your earlier posts:

(01-03-2016 09:33 PM)Jurgen Keller Wrote:  At least the transport roll was totally rotten. I couldn't even measure the correct diameter. So I replaced it with a gummy ring that might not fit well. However, I've no idea if that can have a bad impact on the correct operation.

Did you originally have the card reader connected before replacing the drive wheel, and was it blowing fuses then? I'm wondering if this new wheel is creating too much friction.

No, I didn't. The drive wheel looked so bad that I thought I try to replace it first, before connecting the OCR. Fore sure it would have been a good idea to try to connect the OCR just with the old wheel removed.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Service required for HP 9160A Optical Card Reader - Jurgen Keller - 01-06-2016 08:50 PM



User(s) browsing this thread: 1 Guest(s)