Post Reply 
Hp 50g vertical display problem
05-27-2020, 12:52 PM (This post was last modified: 05-27-2020 03:50 PM by Gene.)
Post: #13
RE: Hp 50g vertical display problem
I set my soldering iron to about 350-400F and used an 1/8" thick piece of silicone tubing as the insulator. I think the temp on the other side of the silicon was around 180-200F. (Used a laser temp gun to measure the surface temperature) This temperature combined with about 2-seconds of moderate pressure, reconnected glue bond and all 10 of my vertical lines.

I've only worked with the connections you have labeled as "red".
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Hp 50g vertical display problem - Randall - 03-22-2016, 02:32 PM
RE: Hp 50g vertical display problem - RHIX - 05-26-2020, 03:18 AM
RE: Hp 50g vertical display problem - RHIX - 05-27-2020 12:52 PM



User(s) browsing this thread: 1 Guest(s)