Programming workflow?

Threaded Mode | Linear Mode

Programming workflow?

11-02-2016, 02:15 PM (This post was last modified: 11-02-2016 02:16 PM by eried.)

Post: #4

eried

Senior Member

Posts: 744
Joined: Dec 2013

RE: Programming workflow?

(11-01-2016 02:06 PM)falcon56215 Wrote: I use Notepad++ to edit with a custom definition file I found on hpcalc.org.

Yes, I do the same with that definition file. Pretty handy!

____________________________________

So, a lot of cases code on the calculator, any opinion of this? Did you enjoy it? (did you used to do the same with older calcs?)

I wonder what jte do... haha Tongue

My website: erwin.ried.cl

« Next Oldest | Next Newest »

Messages In This Thread

Programming workflow? - eried - 11-01-2016, 01:50 AM

RE: Programming workflow? - compsystems - 11-01-2016, 01:14 PM

RE: Programming workflow? - falcon56215 - 11-01-2016, 02:06 PM

RE: Programming workflow? - eried - 11-02-2016 02:15 PM

RE: Programming workflow? - compsystems - 11-02-2016, 04:07 PM

User(s) browsing this thread: 1 Guest(s)

Poll: Which is your workflow when programming the Prime?
	I program directly on the physical calculator
	I use the virtual calculator to program
	I use the Connectivity kit editor
	I use notepad, and copy/paste constantly to the virtual calc/conn kit
	I use Notepad++, and copy/paste constantly to the virtual calc/conn kit
	I do something else

	[Show Results]
Note: This is a public poll, other users will be able to see what you voted for.