Installing software
|
11-03-2016, 09:33 PM
Post: #2
|
|||
|
|||
RE: Installing software
(11-03-2016 09:13 PM)tdh79 Wrote: Hi, I'm new to the 50g and this is the first time I've tried to transfer programs from pc. The PC Connectivity Kit is for the Prime, and does not support the 50g. All you need is Conn4x. When you copy a library to the 50g, it is simply saved as a named variable in the home directory, just like any other object you copy over. You should see it there after you drag-n-drop it. Once copied, the rest must be done on the 50g. You need to recall the library object to the stack and install it, for it's commands to be available. If you copy a library named foo, once you disconnect, do this: 'foo' RCL 2 STO to store that library into Port-2 (which is Flash and doesn't use system ram). Then power-cycle, or press ON-F3 to restart and announce the library to the system. The library is now installed and it's commands should be available. Note: this procedure is correct for about 99% of the available libraries, likely including yours, but some special-purpose libraries have different loading procedures, but if so, it likely came with documentation. hth --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Installing software - tdh79 - 11-03-2016, 09:13 PM
RE: Installing software - rprosperi - 11-03-2016 09:33 PM
RE: Installing software - buffalo - 11-03-2016, 10:30 PM
RE: Installing software - tdh79 - 11-03-2016, 10:43 PM
|
User(s) browsing this thread: 1 Guest(s)