Classic battery door latch 3d model?

[PANAMATIK]

(11-07-2016 02:11 AM)Nate Martin Wrote:  The spice battery door is modeled, I just need to get a couple made to check form, fit, and function. Estimated cost on shapeways is about $5...so I just need to make sure it works.

Is it available meanwhile? Did you make sure it works? I need at least 5 spice battery doors and two classics as well. Thanks for modeling and offering these parts.

I also need a red display cover for an HP-37E, but this seems beyond todays 3D print techniques

Bernhard