Classic battery door latch 3d model?

[Sylvain Cote]

Hello Nate,

(08-20-2017 03:09 PM)Nate Martin Wrote:  Per the note:
4 x HP-41 Port Module Cover (here and here)
-> they do not fit on Port-X-Tender, the extremity is too thick on the inside
I will check today and see what I can adjust. I have a port-x-tender so this should be easy.

I was nit-picking here, the Port-X-Tender is a definitively edge case.
I have two of these and they are filled with standard port plugs when they don't hold actual modules.

(08-20-2017 03:09 PM)Nate Martin Wrote:  I have also been working on the revision to the 71b front port cover, but cannot get the changes to upload correctly.

Just to be on the safe side, I was talking about the HP-71B HP-IL port cover on the back not the HP-71B front ports cover.
IMHO, your HP-71B front ports cover are perfect.

About the HP-41 CL Serial Module Cover NH, I found a way to firmly hold it in place when connecting and disconnecting the external serial cable.
I no longer fear of forgetting to put a restraining finger preventing the plug to get out and thus breaking the internal serial cable.
I will disclose the tip at the upcoming HHC2017 at the same time I do my 41CL Update presentation.

Best regards,

Sylvain