HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Classic battery door latch 3d model?

Post Reply 
Classic battery door latch 3d model?
09-10-2017, 06:31 PM
Post: #59
mfleming Offline
Senior Member
 		Posts: 938
Joined: Jul 2015
RE: Classic battery door latch 3d model?
(09-09-2017 03:40 AM)Nate Martin Wrote:  I think I got these corrected and sent a sample today, I may still need to adjust length slightly but I did get it to snap in place. A couple of prices got wonky during all of my uploads, it was adding a markup which I did not intend to add during a scaling operation.

I still need to check the HP71 IL port cover for Sylvain, and I also uploaded a 41 extended module housing (https://www.shapeways.com/product/L99GKC4UW) today that i need to get a sample print.

What is the overall length of the extended module housing? Looks like there's room enough for an IR diode or, dare I say, GPS module Smile

~Mark
Remember kids, "In a democracy, you get the government you deserve."
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
a few pics of version 2 - Nate Martin - 11-20-2016, 03:38 PM
71B Front Port Covers - Dave Frederickson - 06-17-2017, 07:42 PM
RE: Classic battery door latch 3d model? - mfleming - 09-10-2017 06:31 PM



User(s) browsing this thread: 2 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication