Post Reply 
newRPL - build 1255 released! [updated to 1299]
06-02-2019, 04:38 AM
Post: #462
RE: newRPL - build 1255 released! [official and unofficial]
(06-01-2019 04:47 PM)bzoom Wrote:  My 39gs update from 1180 to 1255 went bad, it seems that paperclip menu is not accessible anymore, zero action on the screen, only clear screen without any pixels.

Update froze after "Erase Finished" line and Conn3x program was not responding anymore.
Another fine moment with Win10.

I guess I have to pop the 39gs case open and use debugger to program bootloader again.
I think I have a ST-link clone laying somewhere...

Just wanted to clarify for other people that might get scared of flashing the new ROM: your issue is not related to newRPL, if it crashed after Erase Finished, the ROM never made it to your calculator. Your comms got stuck who knows why and the transmission got interrupted before anything was programmed.
If this was the case, the bootloader was never erased, so you should be able to reset and use + and - to access the boot loader menu. The timing is not so easy, make sure you try plenty of times before giving up. I never heard of boot loader getting erased on this type of hardware (39,40,50 series), except when I did it myself.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: newRPL - build 1001 released! - pier4r - 12-16-2017, 08:03 AM
newRPL - on Hp 39gs - Martin Hepperle - 06-05-2019, 06:51 AM
RE: newRPL - build 1001 released! - pier4r - 12-23-2017, 10:16 AM
RE: newRPL - build 1001 released! - pier4r - 01-01-2018, 09:42 AM
t - Claudio L. - 01-01-2018, 03:06 PM
RE: newRPL - build 1001 released! - pier4r - 01-01-2018, 03:41 PM
RE: newRPL - build 1001 released! - pier4r - 01-02-2018, 04:54 PM
RE: newRPL - build 1001 released! - pier4r - 01-02-2018, 06:58 PM
newRPL - brickviking - 10-05-2018, 06:01 AM
RE: newRPL - build 1255 released! [official and unofficial] - Claudio L. - 06-02-2019 04:38 AM
How to participate? - erazor - 12-13-2019, 07:12 AM



User(s) browsing this thread: 2 Guest(s)