HP41-CL - Module behaves differently than on 41CX

[hth]

(12-29-2017 10:28 PM)PeterP Wrote:  I then tried to create a pristine 41CX:

• Memory Lost
• MMUDIS
• MMUCLR
• MMUEN
  

This removes access to the YFNZ/YFNX of course but should give me a plain old 41CX. However, upon plugging in the COGO41, the calculator hangs again.

Now I'm stumped and can't think of what else to try.

Question: How is this possible? Any suggestions on what else to try?

It is possible if it uses page 7. Move the YFN* module away from page 7 before you enable the MMU.

Håkan