Given command for Hp prime?

[Lord_Spooglypuff]

Hi all.
I have recently switched out my Ti nspire for a hp prime, and I am struggling to figure out how to set restrictions on equations on the CAS.
For example, on the 84 plus and nspire, restricting equations is done using set notation:
eg: solve(v^2=u^2+2a*s)|v=50,u=5
So how would I convert that to hp prime syntax? I have been doing some digging, and I found that the given symbol exists, but I can't figure out how to get it to work without just displaying syntax errors.
Thank you for your help.

[Arno K]

You simply enter: solve(v^2=u^2+2*a*s,a)|v=50,u=5 using CAS, before that you should make sure the variables are empty: purge(s), purge(a). The | can be taken from the patterns found on the keyboard.
Arno

[Lord_Spooglypuff]

(10-28-2020 12:55 PM)Arno K Wrote:  You simply enter: solve(v^2=u^2+2*a*s,a)|v=50,u=5 using CAS, before that you should make sure the variables are empty: purge(s), purge(a). The | can be taken from the patterns found on the keyboard.
Arno

I did exactly what you did, but all i get is a syntax error. Do you know whats going on?

[rprosperi]

Also, note the additional characters that were added:

solve(v^2=u^2+2*a*s,a)|v=50,u=5

[Lord_Spooglypuff]

I was in CAS mode, but it is still giving out a syntax error.
Does anyone else still know what's happening?

[rprosperi]

After you insert the "|" from the 3rd key in the top row, don't cursor up before you enter the "v=50,u=5 ".

[Lord_Spooglypuff]

It works now, I realized that I was getting the pipe symbol from the character menu on the first key.
Since I used the symbol on the third key instead, it's working
Thank you very much

[Stefan_Titan2944A]

(10-29-2020 01:30 AM)rprosperi Wrote:  After you insert the "|" from the 3rd key in the top row, don't cursor up before you enter the "v=50,u=5 ".

Well, the easiest way is to follow rprosperi's comments.
Top key row, 3rd key, top menu row, 3rd entry .. |

No need to dig through 'Chars' menu.