Post Reply 
Looking for survey program for HP-15C
12-11-2021, 08:03 PM
Post: #1
Looking for survey program for HP-15C
Hi all and greetings from Canada.

I'm on the hunt for a simple survey program for HP15C.

I used to work in the surveying field several years ago and we used a 15C or 11C for calculations
and traverse/inverse/areas for simple lot closures.

I remember that the program was just over 100 program steps.

also, I remember that to start the program I would do the following
to set N and E to 0 .
( 0, ENT, 0, FCN, A ) which would set the N and E to zero.

to run traverse, you would do the following for each leg of your traverse.
enter bearing, R/S, enter quadrant , R/S, enter distance, R/S, N is displayed, R/S, E is displayed.

Once you do your closed traverse, RCL, 3 would give your area in S.F.

to inverse from original point: ( bearing )
RCL , 5, enter, RCL 4, divide, inv, tan, fcn, hms

to inverse from original point: ( distance )
RCL 4, sq, ENT, RCL 5, sq, +, sq rt

any help in finding this program again would be greatly appreciated.
Ron
Find all posts by this user
Quote this message in a reply
12-12-2021, 01:44 AM (This post was last modified: 12-12-2021 02:22 AM by MNH.)
Post: #2
RE: Looking for survey program for HP-15C
(12-11-2021 08:03 PM)scoobieshouse Wrote:  I'm on the hunt for a simple survey program for HP15C.

The website below might help you.

https://surveyorconnect.com/community/so...alculator/

The traverse/inverse/areas programs you want sound easy to write. There's plenty of help available on this website to get you started!
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)