How many BAD BLK?
|
07-27-2014, 12:29 AM
Post: #21
|
|||
|
|||
RE: How many BAD BLK?
(07-26-2014 05:26 PM)Alberto Candel Wrote: I have 2 units, with 12 and 6. The numbers are:Yes 0 and 1 do seem to be marked bad for everybody, and block 0 is the only block guaranteed to be good by the manufacturer. That's enigmagic. Don't know why they're listed as invalid, but no way is block 0 invalid nor probably block 1 in everybody's Prime. Here is the direct quote from the manufacturer's data sheet: "The 1st block, which is placed on 00h block address, is guaranteed to be a valid block up to 1K program/erase cycles with 1bit/528Byte ECC." |
|||
07-27-2014, 12:47 AM
Post: #22
|
|||
|
|||
RE: How many BAD BLK?
(07-26-2014 06:11 PM)Jsather Wrote: Thanks to a picture from ereid at http://www.hpmuseum.org/forum/thread-1803.html , we know the flash memory chip is a K9F2G08UOC whose manufacturer's data sheet can be found at http://www.wasuntech.com/FileUp/file/201...5_1660.pdf . My memory chips have the label K9K2G08UOM. |
|||
07-27-2014, 08:10 PM
Post: #23
|
|||
|
|||
RE: How many BAD BLK?
(07-27-2014 12:47 AM)Alberto Candel Wrote: My memory chips have the label K9K2G08UOM.As far as this thread is concerned, the U0C and U0M have the same minimum of 2008 valid blocks from the factory. There are differences between the U0C and U0M in read cycle time and cache program support, but we can't infer much from that about performance in the Prime. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 3 Guest(s)