Threaded Mode | Linear Mode

Thomas Radtke · 01-22-2014, 03:19 PM

(01-22-2014 01:53 PM)Eddie W. Shore Wrote: Out of curiosity, what are B/O, C/N, and NN? Apologies if I did not write those symbols correctly.

Might be...

B/O = Return
C/N = Run/Stop
NN = Gosub

...as on the MK-52:

MK-52 keyboard mapping

W_Max · (This post was last modified: 01-23-2014 02:48 PM by W_Max.)

All described commands works different in program and run modes

B/O - RETURN/CLEAR PC - Return from subroutine/reset program counter to zero ("rewind" program)
C/N - STOP/RUN - STOP in program, RUN, while in RUN mode (you can interrupt program execution at any time by pressing any key)
NN - GOSUB/Step forward. Return from subroutine/step forward in RUN mode