+- HP Forums (https://www.hpmuseum.org/forum)
+-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html)
+--- Forum: HP Prime (/forum-5.html)
+--- Thread: Unit conversions not possible in home mode (/thread-18504.html)
Unit conversions not possible in home mode - Adiwa - 06-24-2022 08:31 AM
Dear Forum
The examples show the possibility to convert units by the "convert"- command in home mode.
On my Prime I get a syntax error in home mode. I suppose it is, because I'm on RPN and so I can only write a semicolon and not a comma, as it is indicated in the examples. When I go to CAS, then I can do these conversions.
Is my appreciated RPN mode blocking me out of some functions in home mode?
Thanks for your replies
Adrian
RE: Unit conversions not possible in home mode - Didier Lachieze - 06-24-2022 08:57 AM
In RPN mode you have to specify the number of parameters a function takes from the stack. For CONVERT it's 2:
[attachment=10819] [attachment=10820]
RE: Unit conversions not possible in home mode - Adiwa - 06-25-2022 06:35 AM
(06-24-2022 08:57 AM)Didier Lachieze Wrote: In RPN mode you have to specify the number of parameters a function takes from the stack. For CONVERT it's 2:Dear Didier
Thanks very much for your hint, I can do it now in home. The Prime is a very powerfull tool, but it's not a very intuitive tool.
Regards
Adrian