+- HP Forums (https://www.hpmuseum.org/forum)
+-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html)
+--- Forum: HP Prime (/forum-5.html)
+--- Thread: Bug: copying standard form numbers to command line in CAS mode (/thread-5255.html)
Bug: copying standard form numbers to command line in CAS mode - Nigel (UK) - 12-02-2015 02:53 PM
I can't find this bug on the forum (and Tricider won't let me post for some reason):
In CAS mode, calculate 6.63e-34/9.11e-31. Then copy the calculation (the fraction, not the result) back to the command line. The numbers are broken at the exponent "e" character making the expression unsuitable for further use.
Nigel (UK)
RE: Bug: copying standard form numbers to command line in CAS mode - Tim Wessman - 12-02-2015 03:24 PM
Hello,
Thanks. I believe this one was already addressed a while back (internally, not in the public release you have), but will put on the list to check and make sure.
RE: Bug: copying standard form numbers to command line in CAS mode - Nigel (UK) - 12-02-2015 08:14 PM
(12-02-2015 03:24 PM)Tim Wessman Wrote: Hello,
Thanks. I believe this one was already addressed a while back (internally, not in the public release you have), but will put on the list to check and make sure.
Thank you, Tim. Keep up the good work! It is all very much appreciated.
Nigel (UK)