HP67 PCB connector pins

[ishe]

Hi,

I have a HP67 and 3 PCB connectors between the KBD and CPU board has been broken.
Is there a way to find replacement for this pins? I have removed 3 pins from the pcbsense board and replaced the broken ones with those but now the pcbsense board needs those pins. What else could be used to replace those?

Thanks
Istvan

[Hiwi]

hi,
you can solder a small cable or make your own connection with a post connector or pcb connector. 2.54 mm pitch would fit. I use them for replacing broken ribbon cables as well.

I can dig into my cellar and search for some pins. And if I am sucessful I can send them free of any charge to you.

Ralf

[ishe]

Thank you Hiwi!
I am certanly looking for a solution but if you would happen to find those pins that would be great!
I have been thinking to use a modern connector for the PCBsense board and remove those left 7 legacy style pins. Just the height of the connector must match.
Let me know if you find anything.
Thanks, I appreciate your help!
Istvan

(05-08-2024 01:10 PM)Hiwi Wrote:  hi,
you can solder a small cable or make your own connection with a post connector or pcb connector. 2.54 mm pitch would fit. I use them for replacing broken ribbon cables as well.

I can dig into my cellar and search for some pins. And if I am sucessful I can send them free of any charge to you.

Ralf

[Hiwi]

I have found a HP97 board, they are the same, i suppose.
Ralf

[ishe]

Hi Hiwi,

Yes, they have the same PCB connector pins. If you could desolder 3 of those and send to me that would be great!
I can PM you my address.
Thanks
Istvan

[Hiwi]

4 are on the way to you.
Ralf

[ishe]

Thank you Hiwi!
I appreciate it!
Istvan