DM 15L two line display

[AnnoyedOne]

(Today 03:57 PM)dm319 Wrote:  Got to admit, coveting it a lot.

Ok, but I think it is already "branded".

Equivalent to "putting a ring on it"

A1

PS: Swissmicros may sell a few more DM15L's in the near future. A shame that their shipping is so slow (based on recent reports). Perhaps not their fault.

[Ross Barnes]

A user Helix reported that he was unable to stop a running program after loading firmware V33 on his DM15L. I had just installed the firmware before I saw the message. I loaded a short program with an infinite loop, started it, and I was only able to stop it using the Reset pinhole on the back. Could someone else confirm this behavior? Thank you.

See message link below:
Update V33

[rprosperi]

(Today 02:39 PM)ctrclckws Wrote:  

(Yesterday 03:46 PM)Jase Wrote:  Man, that would be cool if the mini-me gets a 2-line option.

It does work on the older credit card size DM15 and DM16

Very sorry, please let me clarify my earlier clarification.

Some of the very earliest DM15 devices cannot have the V33 DM15 f/w installed (IIRC, these had limited ROM size), but this does not affect all earlier DM15 cc-sized models, in fact most of them will work.

Sorry for the poorly worded comments earlier.

[rprosperi]

(Today 08:53 PM)Ross Barnes Wrote:  A user Helix reported that he was unable to stop a running program after loading firmware V33 on his DM15L. I had just installed the firmware before I saw the message. I loaded a short program with an infinite loop, started it, and I was only able to stop it using the Reset pinhole on the back. Could someone else confirm this behavior? Thank you.

See message link below:
Update V33

Please list the program which you are unable to stop, I can't reproduce this problem with another simple looping program, program execution stops properly when I press [R/S] while running, without loss of control.

[Ross Barnes]

It was a simple one:
P/R
LBL A
1
+
GTO A
P/R
GSB A

I tried R/S and every other key and various combos of keys.
Gave up and Reset.
I then ran the program again thinking I might have been in some strange mode
Same result. Reset.

I've already flashed back to V32 since I use the calculator daily.
I am pretty certain that I was running my DM15L with V33 at the slower clock rate because V33 defaulted to the higher clock rate on flashing and I wanted it at the slower clock rate that V32 set by default.

I used the DM15_M1B_xx.hex images.