Post Reply 
How to run binary file with the latest firmware
06-10-2017, 09:04 AM
Post: #1
How to run binary file with the latest firmware
I have found the three-party firmware, but it doesn't work with the latest firmware. The calculator just went black after I had flashed the firmware into it. So how can I run a binary file with the latest firmware?
Find all posts by this user
Quote this message in a reply
06-10-2017, 05:22 PM
Post: #2
RE: How to run binary file with the latest firmware
Excuse me, where have you found the three- party firmware?. Thank you.
Find all posts by this user
Quote this message in a reply
06-12-2017, 05:04 AM
Post: #3
RE: How to run binary file with the latest firmware
(03-16-2017 07:43 PM)Jean-Baptiste Boric Wrote:  Technically, you can install https://github.com/boricj/ripem and run bare metal ELF binaries, but it's just a proof of concept at this point.

But indeed, you can't run native programs with the official firmware.

http://www.hpmuseum.org/forum/thread-7957.html
Find all posts by this user
Quote this message in a reply
06-12-2017, 08:00 AM
Post: #4
RE: How to run binary file with the latest firmware
Looks like I'll have to dust off my disemboweled HP Prime. Actually, I'll have to write a hardware-level emulator first because I'm not going back to the "blind debugging and flashing under Windows" endless cycle ever again.

Can you open a GitHub issue with:
  • hardware revision (DVT, HW-A or HW-C) ;
  • firmware version ;
  • description of symptoms ;
  • link to this thread ;
so that I can keep track of this?
Find all posts by this user
Quote this message in a reply
06-13-2017, 08:55 AM
Post: #5
RE: How to run binary file with the latest firmware
I have open an issueSmilehttps://github.com/boricj/ripem/issues/3
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 2 Guest(s)