New beta 22 April

[calc_freak]

(04-22-2021 06:45 PM)Wes Loewer Wrote:  

(04-22-2021 05:34 PM)Wes Loewer Wrote:  Having the same issue of G1 stuck at x^2+y^2=1 for two different ver A's.

Both were able to go into recovery mode and I was able to downgrade back to their previous versions.

You can enable recovery mode by holding down Symb while doing a paper clip reset. Once you are in recovery mode, then after a little while the Connectivity Kit should detect it and offer to upgrade firmware. If it doesn't detect it, try unplugging and replugging in the usb.

You, sir, also are awarded 10 internets. Many thanks for the reply.