Texas TI-58: Repairing the keyboard bounce and miss to register keystrokes

[jebem]

Reassemble the 9 dome rows

Put back the 9 dome rows by soldering them to the keyboard base at the 9 rows joint points.
I used tooth ticks as dome's alignment guides by inserting them into the two existing small holes in each one of the 9 rows.




Re-apply the thin plastic cover onto the 9 sticky dome rows
Because the dome upper sides are covered with a very strong adhesive layer, it was enough to fix the plastic cover back in place.

Keyboard base populated with the 9 dome rows:


Plastic sheet cover back in its original place.