HP OmniBook 300 find!
|
05-09-2016, 08:30 PM
Post: #16
|
|||
|
|||
RE: HP OmniBook 300 find!
(05-09-2016 04:20 PM)Bill (Smithville NJ) Wrote: Here's some more info on the OB-300. Thanks for the info, Bill. Is there a way to tell which version I have? When I popped out the system ROM card, all I remember seeing on the label was Version 1.0. It works fine with the 32MB Sandisk flash card I use with my 200LX, but I don't have any other cards to use with it (other than a similar 20MB card which thus far has not worked in any computer I've tried it with, so I assume it's dead). As for your earlier comments about replacing the hard drive with flash, I will definitely keep that in mind. Is there a source for the 'door plate' which would allow me to use the PC card slot normally blocked by the hard drive card? Also, is there a known source for the F1041A 2MB RAM card upgrades other than a dead 300 or somesuch? Also, where would they be installed? I noticed a door on the left side of my 300 (opposite the pop-out mouse), but have yet to figure out how to get in there to see what's inside. Again, thanks! -Adam |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)