Post Reply 
pyIPER PIL-Box command error: illegal retval
02-03-2018, 10:35 PM
Post: #3
RE: pyIPER PIL-Box command error: illegal retval
I've checked my USB-serial converter for proper operation, and then modified it to provide 5 volt signals as it was set to 3.3 volts. I have also tried it on a Windows computer with the error that the PIL box is not respondingl I believe the baud rate is correct but my ancient oscilloscope failed before I could measure the actual signal!

I currently suspect a wiring mistake on my part.

Try CC41!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: pyIPER PIL-Box command error: illegal retval - Craig Bladow - 02-03-2018 10:35 PM



User(s) browsing this thread: 2 Guest(s)