New beta 22 April

[Wes Loewer]

(04-22-2021 05:34 PM)Wes Loewer Wrote:  Having the same issue of G1 stuck at x^2+y^2=1 for two different ver A's.

Both were able to go into recovery mode and I was able to downgrade back to their previous versions.

You can enable recovery mode by holding down Symb while doing a paper clip reset. Once you are in recovery mode, then after a little while the Connectivity Kit should detect it and offer to upgrade firmware. If it doesn't detect it, try unplugging and replugging in the usb.