Post Reply 
I'm a noob
12-16-2021, 02:52 PM
Post: #13
RE: I'm a noob
(12-07-2021 02:51 AM)Jacob Wall Wrote:  I was able to install it on a G2 with the same firmware and it appeared to run as expected. I did not go beyond a few test operations to create a new circuit, as this subject is not something I am familiar with.

Maybe try a factory reset? I find it is a necessary thing to do sometimes as for whatever reason the calculator can start 'acting up'.

I'm back now, sorry for taking this long to reply but I have been very busy...

After attempting a factory reset and not changing any settings, the program worked just fine. I then found out that it was all related to how we use commas and dots here in Spain. Here we use the following structure: 123.456,123 whereas mostly everywhere else use the following: 123,456.123

So in the end that's the reason as to why it wouldn't work. I am proud to say that after changing that setting everything works as expected!

Thank you to everyone who tried to help out! And specially thank you Jacob for even trying to run the programs in order to find a solution!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
I'm a noob - JPV99 - 12-02-2021, 09:20 AM
RE: I'm a noob - rprosperi - 12-02-2021, 05:02 PM
RE: I'm a noob - JPV99 - 12-02-2021, 06:40 PM
RE: I'm a noob - Jacob Wall - 12-03-2021, 01:19 AM
RE: I'm a noob - JPV99 - 12-03-2021, 08:51 AM
RE: I'm a noob - toml_12953 - 12-03-2021, 10:41 AM
RE: I'm a noob - JPV99 - 12-03-2021, 10:46 AM
RE: I'm a noob - Jacob Wall - 12-03-2021, 01:38 PM
RE: I'm a noob - JPV99 - 12-03-2021, 03:28 PM
RE: I'm a noob - Jacob Wall - 12-03-2021, 10:50 PM
RE: I'm a noob - JPV99 - 12-06-2021, 10:54 AM
RE: I'm a noob - Jacob Wall - 12-07-2021, 02:51 AM
RE: I'm a noob - JPV99 - 12-16-2021 02:52 PM
RE: I'm a noob - toml_12953 - 12-16-2021, 04:27 PM



User(s) browsing this thread: 2 Guest(s)