Alternative WP34S flashing using Arduino
|
12-07-2015, 09:27 AM
Post: #23
|
|||
|
|||
RE: Alternative WP34S flashing using Arduino
Hi,
I was preparing my Arduino (One) to flash a 20b but then I stopped: the Tx,Rx levels are at 5V, not at 3.3V. I haven't seen any resistor on those lines in the schematics. Most of the Arduino boards are at 5V levels. Did I miss something in the (fine) documentation of this flashing method? Thanks to all Fabio |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)