HP50G - Help using OPENFIRE (GREYSCALE) with SYSRPL

[JeffB]

I would like some help using OPENFIRE with just SYSRPL commands assuming this is possible

Based on the instructions I have tried this

#20 #20 MAKEGROB INVGROB
#3
ROMPTR 6CA 002 ( ->4GRAY )

but just get a grob on the stack with vertical lines

[BINUBALL]

(10-30-2020 06:29 PM)JeffB Wrote:  I would like some help using OPENFIRE with just SYSRPL commands assuming this is possible

Based on the instructions I have tried this

#20 #20 MAKEGROB INVGROB
#3
ROMPTR 6CA 002 ( ->4GRAY )

but just get a grob on the stack with vertical lines

Try execute OFVIEW4 to that grob with vertical lines. Then you can see 20×20 square.

[JeffB]

Thanks BINUBALL for your reply
Been a while since I posted this and forgot abut it
Will try this out
Regards Jeff