Post Reply 
HP-35s Programming- Display text with variable
12-10-2020, 03:34 PM
Post: #1
HP-35s Programming- Display text with variable
40 year HP-41 user... purchased a HP-35s. Trying to display text with variable and have variable in the x register to work on it. I see that flag 10 and pressing "EQN" might allow text typing, but how do I select the pink alpha characters to do so? When I type "L" after "EQN:" I get "^". Please provide "dummy" key press programming instructions, rather than just what I see in examples like "NUMBER IS" ( i.e. what key presses does it take in writing the program to display the text with variable). Also, when my program is stopped (R/S) to show the value at a point in my program, the value displayed is NOT in the x register, so I must "RCL" it to work on that variable. How do I place it in "x" and show it with the text, such that I can just multiply it, divide it or replace it with another number?
Find all posts by this user
Quote this message in a reply
12-11-2020, 12:38 AM (This post was last modified: 12-11-2020 12:39 AM by Joe Horn.)
Post: #2
RE: HP-35s Programming- Display text with variable
After pressing EQN, press RCL before each letter of your desired text. See page 13-16 (that's one page, not a range) in the User's Guide for more info about including messages in programs.

<0|ΙΈ|0>
-Joe-
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 2 Guest(s)