Post Reply 
Assign local variable inside for/start loop
03-17-2021, 08:27 AM
Post: #1
Assign local variable inside for/start loop
I tried to calculate pi with Gauss - Legendre algorithm. So this program input repetition count. there is program code below.
Code:
<< 1 2 √ INV 4 INV -> N A B T <<
0 N FOR X A B + 2 / A B * √ T 2 X ^ A A B + 2 / - SQ * - -> A B T NEXT
>> >>
It error at "-> A B T NEXT". However I have to assign new a, b, t values for calculation.
Of course, I can assign global variable like 'A' STO, but I want to use local variable. Can't I assign a local variable inside a loop?

S.Korean / HP-50G | fx-570EX | fx-570CW | HP-200LX
Visit this user's website Find all posts by this user
Quote this message in a reply
03-17-2021, 09:20 AM
Post: #2
RE: Assign local variable inside for/start loop
How about using a compiled local variable?
Find all posts by this user
Quote this message in a reply
03-17-2021, 10:19 AM
Post: #3
RE: Assign local variable inside for/start loop
(03-17-2021 09:20 AM)MNH Wrote:  How about using a compiled local variable?
What is EXACTLY compiled local variable? I don't know it at all.

S.Korean / HP-50G | fx-570EX | fx-570CW | HP-200LX
Visit this user's website Find all posts by this user
Quote this message in a reply
03-17-2021, 01:35 PM (This post was last modified: 03-17-2021 01:36 PM by Joe Horn.)
Post: #4
RE: Assign local variable inside for/start loop
Since A, B and T already exist as local variables, don't create them again; just use STO as usual to store the new values into them. Replace the second -> A B T with something like 'A' STO 'B' STO 'T' STO (or in the opposite order, depending on the order that they are in the stack). This will store the desired values into the local variables, not into global ones. Also, note that after the inner program ends, those variables will cease to exist, so access them if needed immediately after the NEXT command.

<0|ɸ|0>
-Joe-
Visit this user's website Find all posts by this user
Quote this message in a reply
03-18-2021, 02:58 AM
Post: #5
RE: Assign local variable inside for/start loop
(03-17-2021 01:35 PM)Joe Horn Wrote:  Since A, B and T already exist as local variables, don't create them again; just use STO as usual to store the new values into them. Replace the second -> A B T with something like 'A' STO 'B' STO 'T' STO (or in the opposite order, depending on the order that they are in the stack). This will store the desired values into the local variables, not into global ones. Also, note that after the inner program ends, those variables will cease to exist, so access them if needed immediately after the NEXT command.
It works. Thanks Joe.

S.Korean / HP-50G | fx-570EX | fx-570CW | HP-200LX
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)