NoV-64D and HEPAX Questions

[BitWiz]

Diego & Sylvan,

My NoV-64D is currently in Miami on its way here.

In the mean time I am testing with clonixconfig v6.1 and I have the following questions so far:

1. How do I save a configuration to the PC for later modification before downloading to the NoV-64D?
2. In conjunction with #1, how do I load the saved configuration.
3. Even though I unchecked HEPAX when I clicked on proceed, clonixconfig compiled the HEPX1H-0 through 3 files (according to the mpasm log file). Why would it do this if I deselected HEPAX.
4. Does clonixconfig convert the .ROM files to .asm files and then assembles and links them into the ROM Image?

[Sylvain Cote]

(04-08-2024 01:27 AM)BitWiz Wrote:  1. How do I save a configuration to the PC for later modification before downloading to the NoV-64D?
2. In conjunction with #1, how do I load the saved configuration.

Unfortunately, ClonixConfig cannot save and/or restore a module configuration.

(04-08-2024 01:27 AM)BitWiz Wrote:  3. Even though I unchecked HEPAX when I clicked on proceed, clonixconfig compiled the HEPX1H-0 through 3 files (according to the mpasm log file). Why would it do this if I deselected HEPAX.
4. Does clonixconfig convert the .ROM files to .asm files and then assembles and links them into the ROM Image?

I am letting Diego answering that part.

[BitWiz]

Sylvain and everyone else following this thread.

Thank you all for your help. I think I have it nailed down for my initial load.

See the attached file for what I have figured out.

I am still looking for recommendations for good ROMS to use and play with.

Thank you,

Mike

[Sylvain Cote]

I am not home, I wiil validate your config later.
Do not forget to check for XROM conflict.

[BitWiz]

Thank you. I had forgotten about that.

[BitWiz]

(04-11-2024 11:47 PM)Sylvain Cote Wrote:  I am not home, I wiil validate your config later.
Do not forget to check for XROM conflict.

There are two XROM conflicts in my setup:

1. ZENROM and NOV CHAP ROM
I found the source code for this ROM in an XLS file. As soon as I learn how to compile the M-Code
XLS into a ROM file I can change the XROM number.
2. AMC_OS/X+ and HP-16C ROM. I am unable to find the source for either of these though I might
just not be looking in the right place.

I have attached a copy of the updated configuration file.

Thank you again,

mike